dip switch settings ?

Home Forums platINA dip switch settings ?

This topic contains 1 reply, has 2 voices, and was last updated by  Daniel 5 years, 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #2467

    Detlef Liedtke
    Participant

    hallo there,

    i’ve bought one of your platina pcb’s a couple of months ago and meanwhile i am almost ready with soldering…
    i am wondering if theres a detailed description for the settings of the dip-switches. i was searching several forums, but could not find anything, so i would be very thankful for a description of how to use the dip’s, eg. wich one is for impedance, resistance or amplification.

    thanks is advance, dedel

    #2507

    Daniel
    Keymaster

    Hi Detlef,

    there are two DIP switches. Beside one of them there are only resistors. With this DIP switch you change the amplification.The lower the resistance of the activated resistors the higher the amplification. Start with all switches turn of and then increase the amplification until it seems optimal.
    On the other side you have 2 capacitors and some resistors. With these switches you can set input resistance and input capacity.

    Best regards
    Daniel

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.